1. Turn the Intensity Adjustment Dial/Power Switch to the “OFF” position.
2. Open battery cover on the back of the main unit.
3. Insert batteries according to the polarities shown in the
battery compartment.
4. Close the battery cover.
7
How to Insert Batteries
How to Use
General advice from OMRON on the handling of batteries
•
The supplied batteries are for the trial use only and may wear out in less than three months.
•
Replace the worn batteries with new ones immediately.
•
If you are not going to use the unit for more than three months, remove the batteries.
•
If you leave the unit without using it for a long time when the batteries are included inside, leakage from the
batteries may occur leading to trouble.
•
Do not use new and worn batteries together or different types of batteries together.
•
Insert the batteries with the polarities (+ and –) in correct alignment.
•
When handling the batteries, be sure to read the notes on the batteries.
Standard for battery replacement
If you feel the massage stimulation is weak, the batteries may be worn. Replace the batteries with new ones.
How to Connect the Electrode Cord
1. Turn the Intensity Adjustment Dial/Power Switch to
the “OFF” position.
2. Connect the Electrode Cord with the Main Unit.
Insert the Electrode Cord Plug into the Electrode Cord Jack.
3. Connect the Electrode Cord to the Big Pad.
When using the unit for the first time
Take out the Pads from the clear plastic bag.
❇
Do not peel off the clear film attached to the Pad at this time.
1.5V LR03
OOOOOO
SIZU'AAA'
1.5V LR03
OOOOOO
SIZU'AAA'
TENS-EN01-22[HV-F127]-2 11/17/03 6:49 PM Page 8
