Omron M12 -, Datasheet

XS5

18

•

Tentatively insert the pins to the pin block holes so that the key on 
the pin block will coincide with the key groove on the pin clamp. 
Then insert the cable along with the pin clamp.

•

Loosen the screws on pins 1 to 4 and insert the cores according to 
the pin numbers.

•

Use the dedicated Screwdriver (XW4Z-00B)

*

 and tighten the 

screws securely so that the cores do not pull out (tightening torque: 
0.15 to 0.2 N·m).

•

 Five-pole Connectors

•

Strip the cable sheath for a total of 15 mm and strip the core 
covering for 8 mm for the core to connect to pin 5.

•

Connect the core to pin 5 (in the center) first.

•

Insert the core from the side of the hold with the tab and tighten the 
screw securely (tightening torque: 0.15 to 0.2 N·m), and then cut 
off the excess wire with wire cutters.

•

Bend the cable as shown below, attached the enclosed insulation 
cap, and then strip the other cores. 

•

Connect the cores to pins 1 to 4.

Connecting Shielded Cables to Five-pole Connectors

•

Place the insulation tub on the drain line of the shield and connect 
it to the terminal. 

•

Tighten the screw and then check visually to see if there is 
insulation between the cores.

•

Connect the cores to pins 1 to 4.

*

When tightening the screws, use the dedicated XW4Z-00B 
Screwdriver that matches with the screw-slot dimensions.

(4) Inserting Pin Block

•

Mount the cover to the pin block so that the triangle mark on the pin 
block will coincide with the triangle mark on the cover.

•

If the cover is used for an Angled model, the relationship between 
the position of the polarity key on the engaged side and cable 
connection direction will be determined by the direction in which 
the positioning key is inserted into the cover, which can be rotated 
by 90

°

.

•

Fully insert the positioning key until the positioning key is hidden by 
the casing.

Screw-on Connectors

Pin Block

Pin Clamp

Key groove Key groove

Key

XS5C use

XS5G use

6

±

0.5

Insertion

8

12

12

±

0.5

Cable End Processing

•

 Four-pole Connectors

8

7

8

12

Conductors for
pins 1 to 4

Conductors for
pin 5

Screw

Dedicated

screwdriver

Dedicated

screwdriver

Screw

Tab

Insulation cap

Insulation tube

Drain line

XW4Z-00B
Screwdriver

Lock spring

O-ring

Triangle mark

Positioning key
(triangle mark)

Polarity key

Pin Block
(Soldering Model)

Cover
(Straight Model)

(Crimping Model)

(Angled Model)