NQ-Series diagnostics
Section 7-4
73
Table 7.3: System set-up settings
Pressing the buttons on one of the 2 set-up screens will take you to the
specific set-up procedures for the specific settings.
Setting
Description
TouchScreen Calibrate
To calibrate the touch screen. Refer also to 7-2 Touch
screen calibration.
Brightness Control
To set the brightness of the screen.
Contrast Control
To set the constrast of the screen (NQ5)
RTC Settings
To set the RTC.
Com Port Settings
To set the com port.
ScreenSaver Time
To set the screensaver time.
Application Erase
To erase the application.
Note that if you perform this
action you can not continue with NQ-Series diagnos-
tics.
Firmware Erase
To erase the firmware. Note that if you perform this
action you can not continue with NQ-Series diagnos-
tics.
Beeper Setting
To set the beeper.
Battery Status
To view the battery status.
Clear retentive registers
To clear all retentive registers.
System Information
To view the system information.
Summary of Contents for NQ HMI
