31
Attaching the Hand Strap
Section 2-4
2-4
Attaching the Hand Strap
1,2,3...
1.
There are two holes on the left side of the PT for attaching the hand strap.
Pass both ends of the hand strap through the holes.
2.
Pull the two ends of the hand strap together in the middle, and attach them
using the Velcro strip.
To hang the NSH5 from your neck, attached a commercially available neck
strap like the one shown below. Attach the neck strap to the two neck strap
attachment holes on the bottom of the NSH5.
Select a neck strap that will withstand the 1.1 kg weight of the NSH5 and that
has the following dimensions for the NSH5 attachment holes.
RU
N
F6
F7
F8
F9
F10
F1
F2
F3
F4
F5
Pass both ends of the hand strap
through the two holes.
RUN
F6
F7
F8
F9
F10
F1
F2
F3
F4
F5
The required attachment dimensions are given in the following figure.
200 mm min.
10 mm max.
Summary of Contents for NSH5
