64
Initializing Memory
Section 3-4
3-4
Initializing Memory
If the NT11 is used for the first time or if the screen data is ruined and the
NT11 cannot be normally started, the memory needs to be initialized.
The memory initialization is required in the cases mentioned below.
• When the NT11 is used for the first time or when an error message indi-
cating that the screen data is ruined etc. when the NT11 is started.
• When the screen has disappeared during the start-up or operation.
Use the NT11 DIP SW2-2 “Screen data forced initialize effective/ineffective”;
initializes the memory.
Reference
When an error has occurred, the error messages such as “Screen data cor-
rupted” will be displayed. For the error messages displayed on the screen,
refer to
6-2 Responding to Displayed Error Messages
(page 138).
Note
Initializing the screen data memory will erase entire screen data registered in
the NT11. Make sure that there are backup copies of the screen data on
floppy disks before starting the initialization.
3-4-1
Initialization of the Screen Data
The screen data can be initialized by either of the following two methods.
• Initialization by using the System Menu
• Initialization by using the DIP switch
Initialization by using the System Menu
Initialize the image data memory by following the procedure given below.
[System Menu]
Quit
Transmit Mode
Maintenance Mode
Select “Maintenance
Mode” with the
key,
then press “ENTER”.
PT Setting
I/O Check
Initialize Memory
Memory Switch
Select “Initialize Memory”
with the
key, then press
“ENTER”.
Summary of Contents for NT11 - 01-2004
