2
.Installation and connection
8
Do not use the unit where the maximum temperature exceeds 40
°
C.
●
The battery becomes weak rapidly, which may cause a
fi
re.
●
Doing so may cause a failure or malfunction of the unit.
Do not exceed the ranges speci
fi
ed for environmental conditions during
use/storage.
Do not install or store the unit in the places listed below.
●
Do not store in places where the humidity is lower than 10% or higher than 90%.
●
Do not use the unit in places where the ambient temperature is lower than 0°C or higher than
40°C.
●
Do not use in places where the humidity is lower than 25% or higher than 85%.
●
Do not install/store the unit in closed places such as cabinets with no clearance, places where there
is
fl
ammable or corrosive gas, places exposed to direct sunlight, places with large amounts of dust,
places exposed to shock or vibration, or outdoors.
●
Installation or storing the unit in such a place may cause a
fi
re
.
Do not connect equipment that exceeds the output capacity of the unit.
You can use a plug strip to connect additional devices, but do not connect
devices that exceed the current capacity of the plug strip.
●
The current protection of the unit may operate, which may stop the output.
●
The wiring of the plug strip heats up, which may cause a
fi
re.
Do not pinch or tie the cable of the unit.
●
Doing so may cause the cable to be damaged or heated, which may cause an electric shock or a
fi
re.
●
If the cable is damaged, stop using the unit and have the cable repaired.
For repair, contact us; ____
Do not use any of the included accessories with other devices.
●
The accessories are designed exclusively for use with this unit.
●
Doing so may compromise the safety of devices.
Do not block the air vents on the front and back of the unit (the BN50XS/
BN75XS has air vents on the sides).
●
Doing so will cause the internal temperature to rise, which may cause the unit to fail and the bat-
tery to deteriorate.
●
Leave at least 5 cm of space between the vent and the wall.
Do not connect a transformer such as a voltage transformer or isolating
transformer to the output side.
●
Overcurrent may damage the UPS.
●
Even when connected to the input side, the UPS may fail or malfunction. Make sure to check the
operation before use.
Do not connect devices that cannot be used with commercial power
supply.
●
When the unit’s power switch is turned ON and an error occurs with the connected device, by-
pass operation is performed and commercial power supply is supplied as is to the connected
devices.
Caution
(for installation and connection)
