55
Auxiliary RS-232C interface
Section 3-8
To connect with the unit use the second button in the menu, starting from the
left, see figure below.
When connected with CX-Thermo you can configure the required Tempera-
ture Controller. For detailed information please use the ThermoTool online
help and read the manual of the used Temperature Controller.
Note Make sure that the baud rate settings in CX-Thermo is the same as selected
on the PRT1-SCU11 with DIP-switch 1 and 2. It is required to use the follow-
ing communication format:
• Data length: 7 bits
• Stop bit length: 2 bits
• Parity: even
Summary of Contents for PROFIBUS DP GATEWAY
