9
Standards
Section 1-4
1-4
Standards
The variable speed drives described in this instruction manual comply with the
standards listed in Table 2. For the declarations of conformity contact your
supplier for more information.
1-4-1
Product standard for EMC
Product standard EN(IEC)61800-3, defines the:
First Environment
(Extended EMC) as environment that includes domestic
premises. It also includes establishments directly connected without interme-
diate transformers to a low voltage power supply network that supplies build-
ings used for domestic purposes.
Category C2: Power Drive System (PDS) of rated voltage<1.000 V, which is
neither a plug in device nor a movable device and, when used in the first envi-
ronment, is intended to be installed and commissioned only by a professional.
Second environment
(Standard EMC) includes all other establishments.
Category C3: PDS of rated voltage <1.000 V, intended for use in the second
environment and not intended for use in the first environment.
Category C4: PDS or rated voltage equal or above 1.000 V, or rated current
equal to or above 400 A, or intended for use in complex systems in the sec-
ond environment.
The variable speed drive complies with the product standard
EN(IEC) 61800-3:2004 (Any kind of metal screened cable may be used). The
standard variable speed drive is designed to meet the requirements according
to category C3.
Option board
position 3
“?” = No option
“I” = Encoder
“J” = PTC/PT100
“K” = Extended I/O“
Option board
Fieldbus
position 4
“?” = No option
“L” = DeviceNet
“M” = Profibus-DP
“M1” = Profinet
“N” = RS232/485
“O” = EtherNet Modbus TCP
“O1” = EtherCAT
Liquid Cooling
“?” = No Liquid Cooling
“P” = Liquid Cooling
Standard
“?” = IEC
“Q” = UL
Marine
“?” = No marine option
“R” = Marine option included
Cabinet input options
“?” = No cabinet input options
“S” = Main switch included
“T” = Main contactor included
“U” = Main contactor included
Cabinet output options
“?” = No cabinet output options included
“V” = dU/dt filter included
“W” = dU/dt Overshoot clamp included
“X” = Sinus filter included
“X1” = All-pole sinus filter included
Additional options
“Z1”= Common mode output filter
“Z2”= Cable Gland kit
“Z3”= Motor PTC connection
Options only available for model between 0.37 and 37KW
Options
Letter (“?” means no character)
Summary of Contents for SX-F
