96
NC Unit Error Logs
Section 10-1
10-1-4 Command Execution Check
Data Checks for Data-writing Commands
Item
Name
Code
Cause
Clearing
method
Operation
after error
Initial speed
Initial speed error
1000
The axis parameters’ initial speed set-
ting exceeds the maximum speed des-
ignation.
Transfer the data
again after
checking and
correcting it.
When this
error occurs
during data
transfer, all
data (includ-
ing the data
with the error)
specified for
transfer will
be lost.
All operating
axes will be
decelerated
to a stop.
Initial pulse designa-
tion error
1001
The initial pulse designation is not set to
0000 or 0001.
Maximum
speed
Maximum speed
error
1010
The axis parameters’ maximum speed
setting is outside the settable range (1
to 500 kpps).
Acceleration/
deceleration
data
Acceleration time
error
1310
The axis parameters’ origin search
acceleration time setting is outside the
settable range (0 to 250 s).
Acceleration time
error
1311
to
1319
An acceleration time setting (1 to 9) is
outside the settable range (0 to 250 s).
(The rightmost digit of the error code
indicates the setting with the error.)
Deceleration time
error
1320
The axis parameters’ origin search
deceleration time setting is outside the
settable range (0 to 250 s).
Deceleration time
error
1321
to
1329
A deceleration time setting (1 to 9) is
outside the settable range (0 to 250 s).
(The rightmost digit of the error code
indicates the setting with the error.)
Acceleration/decel-
eration curve error
1330
The axis parameters’ acceleration/
deceleration curve setting is not 0 or 1.
Positioning monitor
time error
1332
The axis parameters’ positioning moni-
tor time is outside the settable range (0
to 9,999 ms).
Speed data
Speed error
1500
to
1599
A speed setting is outside the settable
range (1 pps to 1,000 kpps).
(The last two digits of the code indicate
the speed data number where the error
occurred.)
Origin search Origin compensation
error
1600
The axis parameters’ origin compensa-
tion setting is outside the settable range
(-1,073,741,823 to 1,073,741,823
pulses).
Origin search high
speed error
1601
The axis parameters’ origin search high
speed setting exceeds the axis parame-
ters’ maximum speed setting.
Origin search prox-
imity speed error
1602
The axis parameters’ origin search
proximity setting exceeds the axis
parameters’ maximum speed setting.
Origin search speed
inconsistent
1603
The axis parameters’ origin search high
speed setting is less than or equal to
the origin search proximity speed.
Summary of Contents for SYSMAC W398-E1-1
