55
Editing Parameter Settings
Section 4-3
For 4-axis NC Units, if the same axis is clicked for the To axis as the one
already selected for the From axis, the next To axis will be selected auto-
matically (in the order Y, Z, U, X).
More than one axis can be selected for the To axis (except for the axis al-
ready selected as the From axis).
For 2-axis NC Units, selecting the Y axis as the From axis will automatically
make the X axis the To axis, and vice-versa.
3.
Change the To axis by clicking on and selecting a different axis.
4.
Verify the From and To axes, and click the OK Button.
4-3
Editing Parameter Settings
4-3-1
Parameter Setting Editing Screen
Select Parameters on the project tree, and either double-click or press the
Enter Key.
Example: The following will be displayed as the 4-axis NC Unit parameter Set-
ting Editing Screen.
4-3-2
Editing Parameter Settings
Select a setting or enter settings directly. Refer to 4-2-2 Editing Settings for
editing methods.
To Enter Settings
Selecting Settings From
the Drop-down List
1,2,3...
1.
On the Setting Editing Screen, select the setting to be set, and either click
the drop-down list arrow or press the Space Bar.
2.
Select an item from the expanded drop-down list either by clicking on it di-
rectly, or by using the Up or Down Keys or entering its list number (0, 1, 2
etc.).
3.
Press the Enter Key to collapse the list and set the settings.
Entering Settings Using
the List Numbers
1,2,3...
1.
In the Setting Editing Screen, enter directly the setting to be set.
2.
Press the Enter Key or use the Up or Down Keys to set the setting.
Summary of Contents for SYSMAC W398-E1-1
