41
Adding and Deleting NC Units
Section 3-3
3-3
Adding and Deleting NC Units
3-3-1
Adding an NC Unit
Use the following procedure to add an NC Unit to a PC.
1,2,3...
1.
Select the PC to be added to from the project tree.
2.
Either select Edit/New NC (M), or right-click and select New NC (M) from
the pop-up menu.
3.
Enter the NC Name. New NC
@
(where
@
= 1, 2 etc.) is the default name.
4.
Set the NC Type by clicking on the NC Type drop-down list and selecting.
5.
Select the Unit No. allocated to the NC Unit (as a Special I/O Unit)
6.
Enter a comment if required.
7.
Click the OK Button to add the NC Unit to the project.
3-3-2
Deleting an NC Unit
1,2,3...
1.
Select the NC Unit to be deleted from the project tree, and select Edit/Re-
move DEL, press the DEL Key, or right-click and select Remove/DEL from
the pop-up menu.
2.
A dialog box will be displayed asking “Do you want to delete?” Click the OK
Button.
Summary of Contents for SYSMAC W398-E1-1
