003DH
Communications Error Contents
<3>
bit 0
CRC Error
bit 1
Data Length Error
bit 2
Reserved
bit 3
Parity Error
bit 4
Overrun Error
bit 5
Framing Error
bit 6
Timeout
bit 7 to bit F
Reserved
003EH
Output Frequency
r/min
<4>
003FH
0.01% units
0040H to 004AH
Used for various monitors U1-
.
Refer to U: Monitors on page 332
for parameter details.
004BH
Drive status (U1-12)
bit 0
During Run
bit 1
During Zero Speed
bit 2
During Reverse Run
bit 3
During Fault Reset Signal Input
bit 4
During Speed Agree
bit 5
Drive Ready
bit 6
Alarm
bit 7
Fault
bit 8
During Operation Error (oPE
bit 9
During Momentary Power Loss
bit A
Motor 2 selected
bit B
Reserved
bit E
ComRef status, NetRef status
bit F
ComCtrl status, NetCtrl status
004CH to 007E
Used for various monitors U1-
, U4-
, U5-
and U6-
.
Refer to U: Monitors on page 332
for parameter details.
007FH
Alarm Code,
Refer to Alarm Register Contents on page 374
for alarm codes.
0080H to 0097H
Used for monitors U2-
, U3-
.
Refer to U: Monitors on page 332
for parameter details and
Refer to Fault Trace
Contents on page 373
for register value descriptions.
0098H
High Word of Accumulated Operation Time Monitor (U4-01)
0099H
Low Word of Accumulated Operation Time Monitor (U4-01)
009AH
High Word of Cooling Fan Operation Time Monitor (U4-03)
<5>
009BH
Low Word of Cooling Fan Operation Time Monitor (U4-03)
<5>
00ABH
Drive Rated Current
<2>
00ACH
Motor Speed (Open Loop
Vector only)
r/min units
<4>
00ADH
0.01% units
00B0H
Option Code
Register contains ASCII code of 3rd and 4th digit of the option card type number. Example:
Register value is 5343H for “P3” if a SI-P3 option card is installed.
00B5H
Frequency Reference After
Soft-starter
r/min units
<4>
00B6H
0.01% units
00B7H
Frequency Reference
r/min
<4>
00B8H
0.01% units
00BFH
oPE Error Number
00C0H
Fault contents 3
bit 0
Reserved
bit 1
Undervoltage (Uv1)
bit 2
Control Power Supply Undervoltage (Uv2)
bit 3
Soft Charge Circuit Fault (Uv3)
bit 4
Reserved
bit 5
Ground Fault (GF)
bit 6
Overcurrent (oC)
bit 7
Overvoltage (ov)
bit 8
Heatsink Overheat (oH)
bit 9
Heatsink Overheat (oH1)
bit A
Motor Overload (oL1)
bit B
Drive Overload (oL2)
bit C
Overtorque Detection 1 (oL3)
bit D
Overtorque Detection 2 (oL4)
bit E
Dynamic Braking Transistor Fault (rr)
bit F
Braking Resistor Overheat (rH)
C.10 MEMOBUS/Modbus Data Table
370
SIEP C710606 20 OYMC AC Drive - V1000 User Manual
7/16/2008-13:23
