77
V500-R2 series
User’s Manual
Se
ct
io
n
4
Me
nu Shee
t/Co
mmand List
Section 4
Setting Method
Setting for READ OK signal output
When you want to output reading succeeded to the READ OK signal, set the conditions
of output system and duration, then set them for “signal output (X*Q)”.
The READ NG signal is output when any code other than the labels registered in
“Setting for label registration” (p.79) is read.
Menu sheet
Command
Output the signal (Factory default setting)
_X*Q_
[X*Q
Not output the signal
_X*R_
[X*R
External trigger signal synchronous system (positive logic, H active) (Factory default
setting)
_X*C_
[X*C
External trigger signal synchronous system (negative logic, L active)
_X*D_
[X*D
One-shot system (positive logic, H active)
_X*E_
[X*E
One-shot system (negative logic, L active)
_X*F_
[X*F
One-shot duration: 10 ms
_X*G_
[X*G
One-shot duration: 20 ms
_X*H_
[X*H
One-shot duration: 30 ms
_X*I_
[X*I
Summary of Contents for V500-R2 Series
Page 1: ...Z334 E1 01A Cat No Fixed Laser Type Barcode Reader User s Manual V500 R2 Series...
Page 18: ...16 V500 R2 series User s Manual Introduction Contents Introduction MEMO...
Page 36: ...34 Section 2 Installation V500 R2 series User s Manual Section 2 Wiring and Installation MEMO...
Page 143: ......
