85
RFID System
User's Manual
Section 3
V600 Commands
Section 3
Commands
Auto Commands
Auto commands can execute communications with the RF Tag when the antenna end of the Hand-held
Reader/Writer has been moved close to the RF Tag after the command is sent from the host device.
1. A command is sent from the host device to the Hand-held Reader/Writer.
2. The Hand-held Reader/Writer enters the communications stand-by state with the RF Tag, and the
operation indicator (LED) flashes green.
If the RF Tag is not detected within one minute of sending the command, a timeout will occur and an RF Tag Non-exis-
tent Error will occur. As a result, the operation indicator will flash red.
3. Communications with the RF Tag are performed when the antenna end of the Hand-held Reader/
Writer is moved close to the RF Tag.
4. A response is returned to the host device from the Hand-held Reader/Writer.
If communications end normally, the operation indicator (LED) will light green and then turn OFF.
C
A
D
Comm
u
nications
w
ith RF Tag
Response
Command
Host device
RF Tag
Hand-held Reader/Writer
B
