86
Section 3
V6
00
C
o
mm
an
d
s
RFID System
User's Manual
Section 3
Commands
Button Auto Commands
Button auto commands execute auto commands after a command is sent from the host device and the
activate switch of the Hand-held Reader/Writer is pressed.
1. A command is sent from the host device to the Hand-held Reader/Writer. As a result, the operation
indicator will light green.
2. Press the Hand-held Reader/Writer activate switch.
3. The Hand-held Reader/Writer enters the communications stand-by state with the RF Tag, and the
operation indicator (LED) flashes green.
If the RF Tag is not detected within one minute of sending the command, a timeout will occur and an RF Tag Non-exis-
tent Error will occur. As a result, the operation indicator will flash red.
4. Communications with the RF Tag are performed when the antenna end of the Hand-held Reader/
Writer is moved close to the RF Tag.
5. A response is returned to the host device from the Hand-held Reader/Writer.
If communications end normally, the operation indicator (LED) will light green and then turn OFF.
D
A
E
Comm
u
nications
w
ith RF Tag
Response
Command
B
Press
Hand-held Reader/Writer
Host device
RF Tag
B
