120
Secti
on 4
Ha
nd-
held Re
ade
r/Wr
it
e
r Fu
nct
io
n
s
RFID System
User's Manual
Section 4
Functions
Hand-held Reader/Writer Functions
Multiple Area Control
The Hand-held Reader/Writer can read and write across
several non-consecutive RF Tag memory areas (10 areas
max.) at one time. To use this feature, the number of control
areas is specified using the NUMBER OF CONTROL
AREAS command. ASCII and hexadecimal can be used
simultaneously for the one command control, but reading
and writing cannot be performed simultaneously.
Example: Data in the Following 3 Areas are Read
Refer to
for more details on ASCII and hexadecimal.
Multiple area control can be used only for V600 commands and cannot be used with the V680.
Auto Command OFF Function
If communications with the RF Tag do not begin within one minute (see note) after an auto command
or button auto command is sent from the host device to the Hand-held Reader/Writer after entering the
RF Tag wait status, the Auto Command OFF function automatically aborts the auto command and
returns an " RF Tag non-existent" error (error code 72) to the host device. When the Auto Command
OFF function is not used, the auto command will not be aborted even if one minute passes after
entering the RF Tag wait status.
This function is set using the BASIC FUNCTIONS SETTING (FN) command.
Note:
The one-minute detection time limit before the timeout will occur can be changed by using the
PARAMETER SET command (SP).
Refer to the section on the
for details on the setting method.
Area (1):
Address
0010 (hex)
Number of bytes
05 bytes
Code setting
ASCII
Area (2):
Address
0030 (hex)
Number of bytes
02 bytes
Code setting
Hexadecimal
Area (3):
Address
0035 (hex)
Number of bytes
03 bytes
Code setting
Hexadecimal
0010
(hex)
0011
0012
0013
0014
0035
0036
0037
0030
0031
4
4
5
4
4
F
D
2
F
E
3
3
3
1
2
1
3
2
4
3
“O”
“M”
“R”
“O”
“N”
Area (1)
Area (2)
Area (3)
Command R D A 3 0 0 1 0 0 5 H 0 0 3 0 0 2 H 0 0 3 5 0 3 * CR
Response R D 0 0 O M R O N 1 2 3 4 3 1 3 2 3 3 * CR
Area (1)
Area (2)
Area (3)
