14
Section 1
Usi
ng Heat
-r
es
is
ti
ve
Ta
gs (
V
680
-D1KP58
H
T
N
an
d V6
80
-D1KP58
H
T
)
RFID System
User's Manual
Section 1
Product Overview
Using Heat-resistive Tags (V680-D1KP58HTN and
V680-D1KP58HT)
This section provides information for using Heat-resistive Tags (V680-D1KP58HTN or V680-D1KP58HT).
If you are not using a Heat-resistive Tag, set the Tag memory setting to Standard Mode.
Precautions for Saving Data at High Temperatures
If you are using a Heat-resistive Tag, write the data again after saving the data at a high temperature
even if it is not necessary to change the data. A " high temperature" is one between 110
°
C and 200
°
C.
Using the V680-CA1D/-CA2D
If you are using Heat-resistive Tags (V680-D1KP58HTN or V680-D1KP58HT) and also using the
V680-CA1D/-CA2D, set the Tag memory setting of the V680-CH
@
D (version 1.1 or newer) to CA1D
Mode.
If you are not using the V680-CA1D/-CA2D, the Tag memory setting does not need to be changed.
Refer to information in
Names and Functions of Components
.
Combining the V680-CA1D/-CA2D with Other Models
When using other models of Controller with the V680-CA1D/-CA2D, make sure that the version allows
setting the Tag memory setting to CA1D Mode.
To use the V680-CA5D01-V2/-CA5D02-V2, it must be version 2.3 or newer.
To use the V680-CH
@
D, it must be version 1.1 or newer.
To use the CS/CJ1W-V680C1
@
, it must be version 1.2 or newer.
Refer to
Checking the Version
for information on product versions.
