6-6
Section
Functions
104
6-6-2 Operation Procedure
The following display will appear when the Programming Console is connected.
Press the RESET Key and then SET Key. Then the default state of the operation
mode is displayed.
If the password is entered while the Controller is in MONITOR mode, the Con-
troller in operation will be interrupted. In this case the Controller will wait for the
next input in MONITOR mode.
By changing the key switch setting of the Programming Console, the operating
mode of the Controller will change.
•
MONITOR Mode
In MONITOR mode, communications with ID Tags are possible through the
Programming Console. No command control through the host is possible.
•
RUN Mode
In RUN mode, the Programming Console can display the set data in the Con-
troller and the operating condition of the Controller. No other functions are,
however, available.
•
PROGRAM Mode
The V700-CD1D Controller does not operate in PROGRAM mode.
Set the key switch
to RUN.
Set the key switch to
MONITOR.
Set the key switch
to PROGRAM.
Set the key switch to RUN.
Set the key switch to
PROGRAM.
Password Input Display
Operation Mode Change
AUDIN - 7 bis rue de Tinqueux - 51100 Reims - France - Tel : 03.26.04.20.21 - Fax : 03.26.04.28.20 - Web : http: www.audin.fr - Email : info@audin.fr
