4-3 Reader/Writer Setting
4-3
4-8
4-3-4 Antena and Tag Communications Setting
Set how communications should take place between the Reader/Writer
and a Tag.
1) Reader/Writer-Tag communications speed setting
Set the speed of communications between the Reader/Writer and a Tag
(baud rate from the Reader/Writer to a Tag). The baud rate from a Tag to
the Reader/Writer is fixed (26.5kbps).
This setting can be made by using the Tag Communications mode Setting
Command (CM).
Setting name
(command name)
Default set value
Setting range
Standard mode
Communications speed
setting(CM command)
Fast mode
Fast mode
:The Fast mode, the factory default, is highly recommended
because it provides fast transmission speed for normal use. Its
communication distance, area, and other performance conditions
are same as those in Standard Mode.
2) Receiving antenna setting
This is enabled when using the receiving antenna. The antenna is used
for some specific configurations such as those for the gate antennas. Set
the function according to the respective antenna operation guide. The
function must be disabled for the configurations where the antenna is not
used.
This can be done by using the Receiving Antenna Changeover Command
(AC).
Setting name
(command name)
Default set value
Setting
range
Receiving antenna setting
(AC command)
Disable (the receiving antenna will
not operate)
Enabled,
Disabled
3) I/O Automatic Changeover setting
When the I/O Automatic Changeover Function is enabled, the antenna is
controlled by the I/O Automatic Changeover (OUT3 and OUT4) for
Multiple Repeat (MR) reading, Fast Read Repeat (UR) (I.CODE1 Mode
only), and EAS Check Command (EA) This function should only be
enabled for antennas requiring the I/O automatic changeover. The
function must be disabled for the configurations where the antenna is not
used.
The function is set by the I/O Automatic Changeover Setting Command
(CA)
Setting name
(command name)
Default set value
Setting
range
I/O Automatic
Changeover Setting
Command (CA.)
Disabled
（
Not Automatic
Changeover setting
）
Enabled,
Disabled
: The Operation Manual describes what type of antennas
require the receiving antenna settings or I/O automatic
changeover settings. Follow the respective instructions in
setting these functions.
