F-60
Two-circuit Limit Switch
WL
Spatter-prevention Models
1. Electrical Rating
Blank:
Standard
01:
Microload
2. Actuator Type
CA2:
Roller lever: Standard model
GCA2: Roller lever: High-precision model
H2:
Roller lever: Overtravel, general-purpose model
G2:
Roller lever: Overtravel, high-sensitivity model
D28:
Plunger: Sealed top-roller plunger
3. Built-in Switch Type
Blank:
Standard
55:
Hermetically sealed
4. Indicator Lamp
Blank:
None
LD:
LED indicator lamp (AC/DC common)
LE:
Neon Lamp
5. Wiring Specifications
-M1J-1:
Pre-wired Connector (See note.)
(2-core: DC, NO wiring, connector pins No. 3, 4)
-M1GJ-1:
Pre-wired Connector (See note.)
(2-core: DC, NO wiring, connector pins No. 1, 4)
-DGJS03:
Pre-wired Connector (See note.) (4 core, DC)
Note:
With 0.3-m cable attached.
Ordering Information
■
Classification
1
2
3
4
5
WL - S
Specifications
Standard
Overtravel
High-
precision
Features
Page
Actuators Roller lever
Yes
Yes
Yes
Five models: Roller lever, adjustable roller le-
ver, adjustable rod lever, fork lever lock, rod
spring lever.
77 to
94
62 to
64
69, 73
to 75
Plunger
Yes
---
---
Six models: Top plunger, top-roller plunger,
top-ball plunger, horizontal plunger, horizon-
tal-roller plunger, horizontal-ball plunger.
Flexible rod
Yes
---
---
Two models: coil spring and steel wire.
Load/
contact
Standard load
SPST-NO/
SPST-NC
type
Yes
Standard models use a two-circuit double-
break switch.
Microload
SPST-NO/
SPST-NC
type
Yes
Specifications include gold-plated contacts.
Environ-
ment-re-
sistant
models
(See
note 3.)
Airtight-seal
WL
@
-55
Yes (Cannot be used with heat-resistive
and low-temperature models.)
Uses an airtight-sealed built-in switch.
66, 76
Hermet-
ic seal
Molded
terminals
WL
@
-139
Lead wires are attached.
The case cover and conduit section are mold-
ed from epoxy resin to improve sealing perfor-
mance.
WL
@
-140
WL
@
-141
WL
@
-145
Lead wires are attached.
The case is filled with epoxy resin, to ensure
high sealing performance.
The Head opening is protected from cutting
powder. (WL
@
-141 and -145 models)
Only WLG2, WLCA2, and WLGCA2 can be
fabricated. (WL
@
-141 models.)
Anti-cool-
ant
WL
@
-RP40
The connector can be removed, so it is possi-
ble to use flexible wires in the cable. The
Head can be removed.
WL
@
-RP60
Rubber parts are made from fluorine rubber.
The Head cannot be removed.
Spatter-prevention
WL
@
-S
Yes
To improve spatter prevention during welding,
a heat-resistant resin is used, and screws
and rollers are all made from stainless steel.
67, 69,
71, 73,
76, 89