F-98
Two-circuit Limit Switch
WL
Wiring
Use 1.25-mm lead wires and M4-insulation covered crimp terminals
for wiring.
Crimp Terminal External Dimensions
dz dia.: 4.3
D dia.:
4.5
B:
8.5
L:
21.0
F:
7.8
l
:
9.0 (mm)
Wiring Method
Switch Box Section
Note:
The ground terminal is only installed on models with ground ter-
minals.
Rotating Lever Set Position
All rotating lever models, except the fork lever lock, have a set posi-
tion marker plate. (See page 75.) After operation, set the indicator
needle on the marker plate so that is in the convex section of the
bearing.
Terminal Plate
By using a short circuit plate, as shown in the following diagram, the
Switch can be fabricated into a single-polarity double-break model.
When ordering specify WL Terminal Plate (product code: WL-
9662F).
D dia.
dz dia.
Ground terminal
NO terminal
NC terminal
t = 0.6 Copper plate
In the interest of product improvement, specifications are subject to change without notice.
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Cat. No. C001-E1-13