98
NC Unit Error Logs
Section 10-1
Positioning
sequences
Sequence data error 3000
to
3099
One of the following errors occurred in
the positioning sequence:
The completion code is not in the range
0 to 6.
The initial speed number is not in the
range 00 to 99.
The acceleration time number is not in
the range 0 to 9.
The deceleration time number is not in
the range 0 to 9.
The target speed number is not in the
range 00 to 99.
The dwell time number is not in the
range 00 to 19.
One of the following errors occurred in
the axis designation:
The Y, Z, or U axis was specified for a 1-
axis NC Unit.
The Z or U axis was specified for a 2-
axis NC Unit.
More than one axis is specified for inter-
rupt feeding or speed control, or all axis
designation settings are set to 0.
(The last two digits of the code indicate
the position data number (00 to 99)
where the error occurred.)
Transfer the data
again after
checking and
correcting it.
When this
error occurs
during data
transfer, all
data (includ-
ing the data
with the error)
specified for
transfer will
be lost.
All operating
axes will be
decelerated
to a stop.
Dwell times
Dwell time error
4001
to
4019
These codes indicate that a dwell time
is outside the settable range (0 to 9.99
s).
(The last two digits of the code indicate
the dwell time number (00 to 19) where
the error occurred.)
Item
Name
Code
Cause
Clearing
method
Operation
after error
