6
Monitor
6-4
3.2 I/O monitor detail
When pressing the F1 key (DETAIL), the details of the displayed I/O are displayed.
The "DETAIL" screen displays the point names registered by the support software.
* SIW and SOW detail displays are not available.
■
Input status detail
■
Changing the ten's place of the port number
When pressing the MONITOR key, the ten's place of the DI port changes "0 10 20" to display the monitor
detail. When there is no next DI port, the I/O is displayed in the order shown below.
DI DO MO LO TO SI SO SIW
SOW
■
Changing the one's place of the port number
Use the cursor keys to select [ ] or [ ] on the screen, and then press the ENTER key to change the port
number.
NOTE
The screen display is updated at constant intervals.
Press the ESC key to exit the monitor display and return to the initial screen.
3.3 Changing output status
ON/OFF of the DO, MO, LO, TO, or SO output can be changed in "bit" units.
Step 1
Display the output monitor detail.
Display the output list of the port whose
output ON/OFF you want to change, and
then press the F1 (DETAIL) key.
The "DO MONITOR DETAIL" screen will appear.
Step 2
Specify the port number of the port
whose ON/OFF to change.
Use the cursor keys to select [ ] or [ ] on
the output monitor detail screen, and then
press the ENTER key to change the port.
Changing the output status
Step 2,3
This figure shows the "DO MONITOR1 DETAIL" screen as an example.
Step 3
Change the output status.
Use the cursor keys to select [ON] or [OFF] of
the bit number whose output status to
change, and then press the ENTER key.
The output status is then changed.
Summary of Contents for YRCX Series
