224
S
E
CT
IO
N 6
Tim
ing Ch
arts
Z550
Operation Manual
SECTION 6
Communication with External Devices
Timing Chart 3
Hold measurement is started when the measurement result matches with the trigger conditions
during a continuous measurement.
Assuming the measurement duration is specified to three times the measurement time (*1)
*1 Specify the measurement duration to 200 ms when the measurement time is 100 ms in order to set it
to three times the measurement time.
*2 ALL-PASS and ERROR outputs are always output at the timing when "hold" is set.
*3 Profile data for which arithmetic processing has been completed when the PROFILE command is
received is transmitted.
Measurement mode
Hold&Logging
Continuous measurement
Hold (Self)
Image acquisition
Measurement time
This result matches with
the trigger condition.
Calculation
processing
Terminal block output (*2)
Analog output
(OUT for which hold is set)
PROFILE command
(received by Controller)
PROFILE data
(sent by Controller)
Terminal block output
Analog output
(OUT for which no hold is set)
PROFILE command
GATE output
OFF
ON
PROFILE data
(*3)
RUN output OFF
ON
BUSY output OFF
ON
Output value according to the hold setting
GATE
ON time
GATE
ON delay
operation.book Page 224 Monday, June 6, 2005 10:19 AM
