228
S
E
CT
IO
N 6
Tim
ing Ch
arts
Z550
Operation Manual
SECTION 6
Communication with External Devices
Timing Chart 7
Measurement is performed according to the TRG signal of the terminal block, and hold
measurement is started when the measurement result matches with the trigger conditions.
Assuming the measurement duration is specified to three times the measurement time (*1)
*1 Specify the measurement duration to 200 ms when the measurement time is 100 ms in order to set it
to three times the measurement time.
*2 ALL-PASS and ERROR outputs are always output at the timing when "hold" is set.
Measurement mode
Hold&Logging
Trigger measurement
(External)
Hold (Self)
Image acquisition
Calculation
processing
Terminal block output (*2)
Analog output
(OUT for which hold is set)
PROFILE data
(sent by Controller)
Terminal block output
Analog output
(OUT for which no hold is set)
TRG
of terminal block
OFF
ON
GATE output OFF
ON
RUN output OFF
ON
BUSY output OFF
ON
Output value according to the hold setting
GATE
ON time
GATE
ON delay
Measurement
time
This result matches with
the trigger condition.
operation.book Page 228 Monday, June 6, 2005 10:19 AM