Updating the Firmware
199
ZG User’s Manual
5
APPENDICES
9
Check the message and click the
[OK] button.
The firmware update will start.
During the update, the progress
status will be displayed. Wait until a
message informing completion of
the update is displayed. (The update
takes several minutes to complete).
• During a firmware update, an error may occur on the Controller. Please wait.
• If the update progress bar stops or the update is not completed within 10 minutes, there is a
possibility that the update has failed.
• In this case, notify an OMRON sales representative of the firmware version before the
update and the firmware version in the write file.
10
When the update is completed,
the completion message is
displayed. Follow the on-screen
instructions.
11
Check the message and click the
[OK] button.
After the firmware update is completed, initialize the Controller.
p.41
Important
Important
Summary of Contents for ZG -
