Measurement Settings
65
ZG User’s Manual
3
FUNCTION SETTINGS
< Cross-sectional area >
The cross-sectional area of the profile inside the region is measured.
Measurement of the cross-sectional area is enabled only in the EXP mode.
How to adjust the region p.66
< Calculation >
The measurement results of other tasks can be used for calculation.
The calculation setting is enabled only in the EXP mode.
< Deleting measurement items >
Icon
Description
Area
The cross-sectional area of the
object can be measured. Specify
the bottom face. The cross-
sectional area is calculated by
integrating the distances between
each of the measurement points
and the bottom face.
Icon
Description
Calc
Set any equation to perform addition/subtraction on the
measurement result. The equation can be substituted with
measurement results obtained by other tasks.
Allowable equation: K+mX+nY
• K range: -999.99999 to 999.99999
(default value: 0.00000)
• m/n range:-10.0 to 10.0 (default value: 1.0)
• X/Y range:OFF (default value: OFF), TASK1 to TASK7 (Only
task Nos. smaller than the task No. to which a
calculation is set can be set.)
Icon
Description
Delete
Delete the measurement items that are set to the currently selected
task.
Cross-sectional
area (mm
2
)
Set the area for the cross section.
Illustration of setting
Cross section
Summary of Contents for ZG -
