Error Messages and Countermeasures
118
ZR-RX70 User’s Manual
Error Messages and Countermeasures
List of Error Messages
This section outlines the error messages that are displayed and the countermeasures for those messages.
Display
Details Cause
Countermeasure
Can't adjust zero voltage.
When the input voltage is over 0
point adjustable range,it is displayed.
Please adjust the input voltage
within 10% of ± of a set range.
Data was not captured.
When the logging file that is not
recorded by as much as one point is
replayed, it is displayed.
The error occurs before detecting the
trigger by the file that stops logging.
Please start the data logging.
The replay file name has not been spec-
ified.
When the replay is executed without
selecting the file, it is displayed.
Please select the logging file.
The replay file name is the same as the
save file name.p
When the logging file and the saved
file are selected by the same name
when it preserves between cursors,it
is displayed.
Please change the file name.
EU function had set ON can't change
range.
When the range is changed with scal-
ing on, it is displayed.
Please turn off the scaling function,
and change the range.
The recovery could not be done.
When the power supply is turned off
while data is being written in a built-in
memory, the recovery processing is
done.
However when failing in the recovery
processing, it is displayed.
The recording data cannot be
replayed.
Please do not turn off power while
logging data.
Upper < Lower setting
When the upper and the lower are
opposite in the span setting, it is dis-
played.
Please change to upper < lower.
Too narrow span setting
When the span setting width of volt-
age CH is set by less than 1% of full-
scale, it is displayed.
Please change the span setting
value to 1% or more of full-scale.
Too narrow span setting
When the span setting width of tem-
perature CH is less than 50Åé,it is
displayed.
Please change the span setting
value to 50°C or more.
The load file name has not been speci-
fied.
When the setting file is loaded when
it unselects the file, it is displayed.
Please select the setting file.
Out of input range.
When input value is over range,it is
displayed.
Please change within the range of
can the displayed setting.
Invalid trigger start settings.
Press [Enter] key and change the set-
tings.
When logging is started with the trig-
ger setting not normally set,it is dis-
played.(START)
Please set the start trigger correctly.
Invalid trigger stop settings.
Press [Enter] key and change the set-
tings.
When logging is started with the trig-
ger setting not normally set,it is dis-
played.(STOP)
Please set the stop trigger correctly.
Unable to establish a connection.
In connected test in the network time
setting,when not connected with the
network server,it is displayed.
Please check the network setting
and the synchronous server setting
of ZR-RX.
Summary of Contents for ZR-RX70
