3-30
Se
c
tion 3
SE
T
U
P
ZS-L
User’s Manual
Section 3
Setting Output Processing of Sensing Information
■
Setting Zero Reset Memory
You can select whether or not to hold the measured value zero reset level even if the
power is turned OFF.
FUN Mode-[SYSTEM]-[ZERORST]
Turn [OFF] zero reset memory if, as in the example below, the zero point is reset for
each measurement.
Example: When the step of the sensing object is measured
• When turning the power ON, if you want to keep the zero reset level data that was in effect when
the power was turned OFF last time, make sure that zero reset memory is enabled.If zero reset
memory is enabled, the zero reset level data will be written in the Sensor Controller non-volatile
memory (EEPROM) at each zero reset.The EEPROM can be written a maximum of 100,000
times. Writing the zero reset level for each measurement can, therefore, use up the life of the
memory and lead to malfunctions.
• Even if zero reset memory is enabled, the zero reset level will be held also when it is saved. Zero
reset will continue after startup when these functions have been changed.
Setting
Description
OFF
Zero reset is canceled when the power is turned OFF.(default value)
ON
The zero reset level is saved to memory even if the power is turned OFF.
Sensor Head
Direction of movement
Zero reset
executed
Zero reset
executed
Zero reset
executed
This step
is mea-
sured.
Summary of Contents for ZS-L -
