Section6
I/
O
Section6
Settings for Processing when Measurement Cannot be Performed
6-15
ZS-HL
User’s Manual
Settings for Processing when Measurement Cannot be Performed
Set the output methods for linear, judge, and terminal block when a non-measurement
state occurs temporarily due to insufficient received light amount or the reset input state,
for example.
Example: When the waveform skips due to insufficient received light amount
X
FUN mode-[I/O SET]-[NO_MEAS]
In hold measurement, the output before the first hold value is obtained will be the same as [CLAMP]
even if [KEEP] is set.
■
Setting the clamp value
If [CLAMP] is selected for the processing when measurement cannot be performed, set
the clamp value to be output.
• For linear output
X
FUN mode-[I/O SET]-[ANALOG]-[CLAMP]
• For terminal block output
X
FUN mode-[I/O SET]-[TERMINAL]-[CLAMP]
Setting
Outputs
Linear Output/Terminal Block Output
Judgment Output
KEEP
The status immediately before measurement is stopped is held and output.
CLAMP
(default value)
Outputs the set CLAMP value (abnormal
value).
All OFF
Setting
When current is output: MIN (approximately 2mA), MAX (approximately 25mA, default value), 4 to 20mA (every 1mA)
When voltage is output: MIN (approximately -11V), MAX (approximately 11V, default value), -10 to 10V (every 1V)
Setting
0 to 65535 (default value: 65535)
Direction of
workpiece
movement
Amount of displacement
Amount of displacement
State with waveform skip caused
by insufficient light amount
As the value before the skip occurred is kept,
this is effective in canceling waveform skip.
When [KEEP] is selected
Summary of Contents for ZS--LD10GT
