RUN Mode
Section 4-3
117
Releasing the Zero Reset
4-3-5
Other RUN Mode Functions
Timing Input
The timing input is controlled by pressing the UP Key (
).
The timing input is enabled only in Hold Mode.
The timing input can also be controlled using the external timing input.
Reset Input
The reset input is controlled by pressing the DOWN Key (
).
The reset input is effective when the key is pressed for 3 seconds or
longer.
The reset input can also be controlled using the external reset input.
When the reset input is used, operation will be according to setting for non-
measurement table in
under
Refer
under
Set the mode switch to RUN.
Hold the ENT and RIGHT Keys down
together for about 3 seconds when the
zero point has been reset.
The zero reset can also be released
using the external zero reset input. The
operation can be repeated as required.
RUN T FUN
The previous display will be resumed
and the zero reset indicator will turned
OFF.
Hold the ENT and RIGHT
Keys down together for
about 3 seconds.
+
Z157-E1-01C.book Page 117 Thursday, August 31, 2006 5:13 PM
