FUN (Function) Mode
Section 4-5
133
4-5-7
Setting Scaling
The procedure used to set scaling is shown below.
Scaling function
Start the first point scaling
value setting by pressing
the UP, DOWN, LEFT,
and RIGHT Keys.
First poi nt
scaling
Measured value
Numeric value setting procedure is the
same as that in other RUN Mode settings.
First point scaling value
(without decimal point)
Measured value
Press the LEFT and
RIGHT Keys to change
the decimal point.
First point scaling (with
decimal point)
Measured value
Pre
to invert the display
values.
ss the UP and DOWN
Display inverted/not inverted
Not inverted.
Inverted.
Second point
scaling
Measured value
Input the second point scaling (same as
first point). Decimal point is not changed.
Perform the one-point scaling operation
(the offset).
Perform the two-point scaling operation
(the offset
and range).
Scaling ON
Scaling OFF
ON
OFF
Scaling is
turned OFF.
Start the second point
scaling value setting by
pressing the UP, DOWN,
LEFT, and RIGHT Keys.
Press the
ENT Key to
move to the
decimal point
setting.
Press the ENT
key to move
to the display
inversion
setting.
Press the
ENT Key to
move to
the second
point scaling.
Press the ENT Key
to finish the scaling
value setting.
Set the workpiece at the
position where the
display value change is
required. Directly input
the new value.
Display value is
inverted if
"Inverted" is
selected.
Set the workpiece at the
position where the
display value change is
required. Directly input
the new value.
Measured value (actively changes
with display inversion setting)
Z157-E1-01C.book Page 133 Thursday, August 31, 2006 5:13 PM
