AP0101AT2L00XPGAH3
−
GEVB
3
Jumper Pin Locations
The jumpers on headboards start with Pin 1 on the
leftmost side of the pin. Grouped jumpers increase in pin
size with each jumper added.
Figure 5. Pin Locations for a Single Jumper. Pin 1 is Located at the Leftmost Side
and Increases as it Moves to the Right
Pins 1
−
4
Pin 1
Figure 6. Pin Locations and Assignments of Grouped Jumpers.
Pin 1 is Located at the Top-Left Corner and Increases in a Zigzag Fashion Shown in the Picture
Pins 1 and 2
Pin 1
Pins 3 and 4
Pins 5 and 6
Pins 7 and 8
Pins 9 and 10
Jumper/Header Functions & Default Positions
Table 1. JUMPERS AND HEADERS
Jumper/Header No.
Jumper/Header Name
Pins
Description
P1
BGLE_SCL_ISP
1
−
2 (Default)
Demo 3 Baseboard I
2
C is Master
2
−
3
Beagle Board is Master
P3
BGLE_SDA_ISP
1
−
2 (Default)
Demo 3 Baseboard I
2
C is Master
2
−
3
Beagle Board is Master
P5
SADDR
1
−
2(Default)
SADDR: Address Set to 0x90
2
−
3
SADDR: Address Set to 0xBA
P7
STANDBY
2
−
3 (Default)
Active Mode
1
−
2
Standby Mode
Open
Auto Serial Control
P8
TRST_N
1
−
2(Default)
Test Mode
2
−
3
Reset Mode
P11
SPI Memory Selection
2
−
3 (Default)
EEPROM Disable/Flash Enable
1
−
2
Flash Disable/EEPROM Enable
P10, P12
SPI_SDI
P10 Open,
P12 1
−
2 (Default)
HOST Mode
P10 Open,
P12 1
−
2
FLASH Mode
P10 1
−
2,
P12 1
−
2
AUTO Config Mode