Confidential
15
29/08/2016
•
After setup, the LED current programming procedure is actually entered when,
powering up the system, the button S3 is kept pressed. Details on the procedure are
reported below.
1. When entering programming procedure, the LED DS1 will start blinking. Release
button S3. Before driving current into the LED strings, the microcontroller will wait that
the user brings the trimmers P1 and P2 (current setting knobs) to the left most
position (counter-clock-wise) to preselect the minimum current level: whenever this
position is attained, the LDM will drive currents in both LED strings. At any time, the
sequence can be exited without save by pressing
“S
2
”
;
2. Adjust the current in the LEDs. The right setting can be found by human visual
perception such as lighting of a dark room (never look directly in the LED source to
potential avoid health hazard or dazzling!), light intensity measurement, a current
measurement probe, or series multimeter in current sensing mode;
3. Once the desired current is found, new settings are save by pressing
“S
1
”
;
4. As an alternative, original factory settings can always be restored with
the“S
3
”
button.
Please note that any LED string between 2V and 60V can be used. The firmware will limit
the current so that 10W maximum per channel can be delivered.
NCV78763 LDM A REF DES KIT: APRGM – Procedure #1
Summary of Contents for NCV78763 LDM A REFERENCE DESIGN KIT
