Step 3
Insert Safety Tether Insert the safety tether provided
into the yellow mark tether hole on the console below the
display. The treadmill is now ready for use.
Step 4
First place the rubber protection sleeve at each side of
U-shaped tube, assembly 2 ends of U-shaped tube to iron
plate of left and right stand column with M8*40 screws, lock
with nuts(special attention, the middle screw hole of U-shaped
tube point to the beveled up direction,U-tube should not trap
the L iron.put on the above it's approved.down U-tube with
foam , and upper without it ) see on the right picture
Step 5
Functional frame. Use two M8*65 screws to fix the
functional frame on the top and bottom U tube.
Step 6
(only for multifunction)
Massage
First, screw off the three M8*16 screws below the massage
machine head, (includeflat washers and spring washers), and
then place the massage machine head on the functional frame,
and tighten up with the above unloaded screws.
Technical data
Assembly size: 169,5 x 66,5 x 114,5 cm
Max user’s weight: 110 kgs
N.W: 48 kgs
G.W: 56 kgs
Running belt: 1200 x 400 mm
Summary of Contents for ABI17-19-098
Page 1: ...BE4540...
