The Search Method
If your Television or Video Recorder, does not respond to the
ONE FOR ALL 3 after you have tried all the codes listed for
your brand, try searching for your code. The Search Method
may also work if your brand is not listed at all.
Let's say you cannot get your ONE FOR ALL 3 to control your
Television.
To search for your TV code:
Switch your Television on.
Press the
TV
key on your ONE FOR ALL 3.
Aim the ONE FOR ALL 3 at your
Television.
Press and hold down
MAGIC
until the ONE FOR ALL 3’s red
light blinks twice. Then, press
9 9 1
.
The red light will blink twice.
Now, alternate between
TV
and
POWER
,
over and over, until your Television turns
off. You may have to press these keys
many times, so please be patient.
Remember to keep pointing the ONE
FOR ALL 3 at your Television when you
press the POWER and TV keys.
When your Television turns off, press
MAGIC
. Don't forget, press MAGIC as
soon as your Television turns off.
The ONE FOR ALL remote should now be
ready to operate your device. Turn your
device back on and try all the remote’s
functions to ensure they are working
properly. If some of the ONE FOR ALL’s
commands are not operating correctly,
try the search method again. You may be
using the wrong code.
8
Installation
Important notes:
- To search for the code for your Video follow the instructions
above only press VCR during steps 2 and 4.
- If your Video's original remote control does not have a power
key, press PLAY instead of POWER when searching for your code.
- During step 4, you may have to press these keys many times (up
to 150!) so be patient. Remember you must aim the ONE FOR
ALL at your device the entire time you are searching for your
code.
1
2
3
5
6
4
