5.
Enter a macro sequence of up to 15 keys. For our
example, press the following keys once in this order:
TV
-
7
-
1
NOTE: If you have access to over 100 channels, add a
0
before the channel numbers (e.g.,
0
-
7
-
1
). If the original
remote control required pressing an
Enter
key to change the
channel, also press the
Enter
key after the channel number
(e.g.,
0
-
7
-
1
-
ENTER
).
NOTE: An
[ERROR]
message, followed by
[MAX = 15]
alerts
you that the macro sequence must be 15 keys or less.
After pressing the first key (in the macro sequence),
you will see the display change to
[SEL TO END]
. This
message acts as a reminder to use
SELECT
to end the
sequence (see next step).
6.
To end the macro sequence, press and hold
SELECT
until you see
[SUCCESS]
appear in the display,
followed by
[EXIT SETUP]
. The URC-9910 remote
control will automatically exit the programming
mode and return to normal operation.
Now when you press
M1
, you will instantly see cable channel 71 on
your TV set.
Programming A Master Power Key With Instant
Channel Selection
A macro key can be programmed to turn on and off your devices as
well. For example, let’s set up a sequence that will turn on the TV
and tune it to channel 3, and then turn on the cable converter and
tune it to a premium channel (e.g., 11).
NOTE: This example assumes all equipment is turned off and that the TV is
connected through the cable converter with TV tuning set to channel 3.
1.
Perform steps 1 through 4 of the previous section,
Programming A Favorite Channel
on page 34.
However, this time in step 4, substitute another open
macro key (e.g.,
M2
).
2.
Enter a macro sequence of up to 15 keys. For our
example, press the following keys once in this order:
CBL
-
POWER
-
TV
-
POWER
-
0
-
3
-
CBL
-
1
-
1
NOTE: If you have access to over 100 channels, add an
0
before each set of channel numbers (e.g.,
0
-
0
-
3
and
0
-
1
-
1
).
If the original remote control required pressing an
Enter
key
to change the channel, also press the
Enter
key after each
channel number (e.g.,
0
-
0
-
3
-
ENTER
and
0
-
1
-
1
-
ENTER
).
continued on next page...
SELECT
35