Adding The IR Signal Extension Cord
Included with the URC-9910 remote control package is an
IR Signal
Extension Cord
for use with a home theater device that is not in
direct line-of-sight of the
IR/RF Command Center
.
If you are having problems remotely controlling a home theater
device from another room, try performing the following installation:
1.
Plug the 4-foot
IR Signal Extension Cord
into the
back of the
IR/RF Command Center
.
2.
Run the
IR Signal Extension Cord
to the device that is
not in line-of-sight of the
IR/RF Command Center
.
3.
Using the supplied double-sided tape, attach the
IR Signal Extension Cord
so that its
LED
is over or
next to the IR sensor of your home theater device.
LED
4.
Test the installation by again taking the URC-9910
remote control into another room in your home, up
to 100 feet* away. Select a device key (e.g.,
TV
) and
press it once. Then press
POWER
once.
The
IR/RF Command Center
will convert the RF sig-
nal from the URC-9910 remote control into an IR
signal and transmit that signal through the IR Signal
Extension Cord to turn on your device (e.g.,
TV
).
If it does not turn on, try repositioning the
LED
until
the device can be controlled, then re-attach the
LED
.
*Distance may vary
53