5
Battery Precautions:
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or
rechargeable (nickel cadmium) batteries.
• Always remove old, weak or worn-out batteries
promptly and recycle or dispose of them in
accordance with Local and National Regulations.
Programming Device Control
This remote is preprogrammed at the factory to operate
an RCA TV, a Sony DVD player, a Motorola cable box,
and an RCA VCR. To control devices other than the
default brands, perform the following steps; otherwise
skip this section:
1. Turn on a desired device (e.g., VCR or DVD player)
and, if applicable, insert media (e.g., cassette or disc).
NOTE:
Please read steps 2 through 4 completely
before proceeding. Highlight or write down the
codes and device you wish to program before
starting step 2.
2. On the remote control, press a device key once (i.e.,
VCR
,
DVD
,
CBL/SAT (DTC)
, or
TV
).
NOTES:
• To program control of a VCR, PVR (or DVR), TV/VCR
Combo, or TV/VCR/DVD Player Combo press
VCR
once. After programming a VCR Combo device,
you will be able to control channel selection,
volume, and VCR functions.
•
To program control of a DVD Player, DVD Player/
VCR Combo, or TV/DVD Player Combo, press
DVD
once. After programming a DVD Combo device,
you will be able to control channel selection,
volume, and DVD functions.
•
To program control of a Cable Box, Cable Box/PVR
(or DVR) Combo, Satellite Receiver, or a Satellite
Receiver/PVR (or DVR) Combo, press
CBL/SAT
(DTC)
once.
3. Press and hold
SET
until the LED (red light) blinks
twice, then release
SET
.
4. Use the accompanying code list to locate the type
of device and brand name and then enter the
first four-digit code for your device. If performed
correctly, the LED will blink twice.
NOTE:
If the LED did not blink twice, repeat steps 2
through 4 and enter the same code again.
5. Aim the remote control at the device and press
PWR
(Power) once. The device should turn off. If it does not,
repeat steps 2 through 5, trying each code for your
brand until you find one that works. If it still doesn’t
work, try Searching For Your Code on next page.
NOTE:
If the device does not have a Power key,
press
PLAY
.
