• Press and hold the <<TV>> key for 3 seconds; until the setup LED lights up.
This enables the protocol and brand selection function for the TV device, the
mode LED will remain on. To enable selection for AUX device, press <Mute>
key after hold <<TV>> key for 3 secs , the TV-mode led will give a Set-up
Confirmation
blink.
• Release the key and enter the 4-digit Brand-id (please refer to brand ID
table guide) for the TV/AUX by pressing each digit key in sequence.
With the first 3 digits, the device-LED will give a reverse blink.
At the fourth digit, the device LED gives two reverse blinks and remains on
(the search will include all code sets that are linked to the selected brand,
or it will search through all code sets in the universal database if brand
number 0000 was selected).
• Press the <<POWER>> or <<MUTE>> key continuously; after 5 secs a
power or mute IR-command is transmitted for the next universal code-set
in the code-set list for the selected brand. The device-LED will turn off durin
tranmission of the IR-command. When the <<POWER>> or <<MUTE>>
key is held continuously then subsequent universal code-sets will be selected
automatically and a sequence of standby or mute IR-command of the next
universal code-set is transmitted.
In the case that brand number 0000 was selected the whole database of either
TV or Aux is scanned. The device-LED shows a reverse blink for each transmission.
7
Turn on the TV/Audio