24
Programming a Macro
You can program your MF-355RF to issue a sequence of commands
at the press of one button. For example, you may want to turn off
your TV, VCR and Satellite Receiver at the same time.
Example:
To set up the Macro mentioned above on the key
labeled A
on your MF-355RF:
1. Press and hold SETUP until
red light (LED under device key)
blinks twice (the red light will blink once then twice).
2.
Press
9 9 5
.
3.
Then press the
A key
to which the Macro will be assigned.
4.
Next press
TV, POWER, VCR, POWER, SAT, POWER
.
5.
To store the Macro,
press and hold SETUP until
red light
(LED under device key) blinks twice (the red light will blink
once then twice).
Result:
whenever you press the A key, the MF-355RF will turn off
your TV, VCR and Satellite Receiver.
- Each MACRO can consist of a maximum of 15 key strokes.
- Make sure that you program a Macro on a spare key that you
don’t use in any mode (e.g. A, B, C, D keys).
- Once you program a Macro on a specific key, the sequence will
work regardless of the mode you are using.
- If you had to hold down a key for a few seconds on the original
remote control to get a function, this function may not work in a
macro on your MF-355RF remote.
To erase a Macro
Example. To erase the Macro from the A key, press:
SETUP*
9 9 5
A key
SETUP*
* Here you must hold down SETUP until the red light blinks twice.
Summary of Contents for MF 355RF
