background image

Step 1:  

Installing the Batteries

Step 3:  

Setting Up Your  Devices

1

1

2

Match the batteries to the + and - marks inside
the battery case, then insert the batteries.

3

Press the battery cover back into place.

1st TV code

2nd TV code

3rd TV code

1st VCR code

2nd VCR code

3rd VCR code

1st Cable code

2nd Cable code

3rd Cable Code

Step 2:  

Looking Up Your Electronic Device Code

You will need o

ne of these codes to program your One For All

®

 So

Easy 3 Device remote.

Look at your Electronic Device to find out the brand name and
write it in the space below:

TV

________________________

VCR _______________________

Cable _______________________

1

2

Your 

One For All

® 

So Easy 3 Device 

needs two (2) new AAA

alkaline batteries. To install the batteries:

On the back of the 

One For All

®  

So Easy 3

Device

,  push down on the tab and lift the

cover off.

Set-Up Codes

RCA

1213

Sony 1111

Turn on your TV, VCR or Cable Box, depending on the
device you are programming.

2

Press 

TV*

 and  release.  Press and hold 

SETUP

until the One For All

®

 So Easy 3 Device's red

light blinks twice.  Release 

SETUP

.

* Note:

  

When setting up your VCR and/or Cable Box,

substitute the appropriate device key (VCR or CBL).

3

Using the example
shown on the
right, enter the
first four-digit
code you wrote
down for the
device you are
setting up.  (See
"Looking Up Your
Electronic Device
Code".)  If you put
in the code
correctly, the red
light will blink
twice.

4

Test the unit by pressing 

POWER

.  The red

light (LED) should blink once.

Note

:  Removing the batteries for more than 30 minutes will require you to

reprogram the remote control.

+

Find your Device brand in the listing on the
reverse side of these instructions.  The most
popular codes are listed first.  Write your codes
here:

How to Enter Codes

If your TV  Press
code is:

1

2

3

4

TV Set Up

Aim the One For All

®

 So Easy3 Device at your

TV and press 

POWER.  

Your TV should turn off.

If it doesn't, repeat Steps 2-4, trying each code listed
for your brand until you find the one that operates
your  TV.

VCR Set Up

Aim the One For All

®

 So Easy3 Device at your

VCR and press 

POWER.  

Your VCR should turn

off.  If it doesn't, repeat Steps 2-4, trying each code
listed for your brand until you find the one that
operates your VCR.  If your original VCR remote
did not have a 

POWER

 key, put a tape in your

VCR and press 

PLAY

 on the One For All

®

 So

Easy3 Device.

Cable Set Up

Aim the One For All

®

 So Easy 3 Device at your

Cable Box and press 

POWER.  

Your Cable Box

should turn off.  If it doesn't, repeat Steps 2-4, trying
each code listed for your brand until you find the
one that operates your Cable Box.  If your original
Cable Box remote did not have a 

"ON"

 key, Use

CH +

 on the One For All

®

 So Easy 3 Device to

turn your Cable Box on.

4

or

or

Reviews: