12
W W W.ONEFORALL.COM
Trouble-Shooting
Problem:
Your brand is not listed in the
code section?
The ONE FOR ALL does not
operate your device(s)?
The ONE FOR ALL is not
performing commands
properly?
Problems changing channels?
Video not recording?
The ONE FOR ALL does not
respond after pressing a key?
The red light does not blink
when you press a key?
Solution:
Try the search method on page 7.
A) Try all the codes listed for your
brand.
B) Try the search method on page 7.
You may be using the wrong code. Try
repeating the Direct Set-Up using
another code listed under your brand
or start the search method over again
to locate the proper code.
Enter the programme number exactly
as you would on your original remote.
As a safety feature on your ONE FOR
ALL, you must press the Record key
twice.
Make sure you are using new batteries
and are aiming the ONE FOR ALL at
your device.
Replace batteries with 2 fresh, new
“AA/LR6” alkaline batteries.
ONE FOR ALL Recall (Previous Channel)
If your television has a Recall or Previous / Last Channel function, the Recall
key allows you to access this function. If, however, your television does not
have a Recall or Previous / Last Channel function, then you can set up your
own two favourite channels with the ONE FOR ALL Recall function.
The ONE FOR ALL Recall function allows you to program up to two channels,
each consisting of a maximum of 4 key presses per channel entry. This allows you
to swap back and forth between two channels with the press of a single key.
1
Press the device key (
TV
or
SAT
).
2
Press the
MAGIC
and
RECALL
keys simultaneously, until the red
light blinks twice.
3
Enter the first channel number
exactly as you would on your
original remote
(e.g.
<-/-->, <1>, <2>
to get channel number 12).
4
Press
RECALL
once and release.
5
Enter the second channel number
exactly as you would on your
original remote
(e.g.
<-/-->, <2>, <3>
to get channel number 23).
6
Press the
MAGIC
key, and the red light blinks twice.
Now, if you press RECALL, you will obtain the second channel programmed
(being <23>) and if you press RECALL again you will obtain the first chan-
nel programmed (being <12> in our example).
To reset the RECALL key:
1
Press the device key (
TV
or
SAT
).
2
Press
MAGIC
and
RECALL simultaneously
until the red light
blinks twice.
3
Press
RECALL
and release.
4
Press
MAGIC
and release and the red light will blink twice.
Important notes:
- To enter only one channel number, skip steps 4 & 5.
- If two channel numbers have been stored previously, entering one new
channel will delete the oldest entry.
