10
W W W.ONEFORALL.COM
The ONE FOR ALL Sleeptimer
If your television does
not
have a sleeptimer function built in, you can
install the ONE FOR ALL sleeptimer function. To do so:
1
Press and hold MAGIC
until the red light blinks twice.
2
Press
9 7 0
. The red light will blink twice again. It is only necessary
to perform steps 1 and 2 once. To set the timer, continue with
the steps below. To deactivate the ONE FOR ALL sleeptimer, repeat
step 1 and 2 above.
Setting the ONE FOR ALL Sleeptimer:
Press and release
MAGIC
then press
POWER
.
The red light will blink once which indicates the
timer is set for 15 minutes. To increase the timer,
simply press
POWER
again (this must be done
within 5 seconds). The light will blink twice
indicating the timer is set for 30 minutes (2x 15).
You can press
POWER
to a maximum of four times
which will set the timer to 60 minutes.
Once you have set the timer to the desired time, set your ONE FOR ALL
remote down, pointing it at your television. When the programmed
amount of time has elapsed, the ONE FOR ALL will send the command
for POWER, hence turning off your television.
ONE FOR ALL Recall (Previous Channel)
The ONE FOR ALL Recall function allows you to program up to two
channels, each consisting of a maximum of 4 key presses per channel
entry. This allows you to swap back and forth between two channels
with the press of a single key.
1
Press the
MAGIC and RECALL keys together
, until the red light
blinks twice.
2
Enter the first channel number
exactly as you would on your
original remote
(e.g. <
-/--
>, <
1
>, <
2
> to get channel number 12)
3
Press
RECALL once
and release.
4
Enter the second channel number
exactly as you would on your
original remote
(e.g. <
-/--
>, <
2
>, <
3
> to get channel number 23)
5
Press the
MAGIC key
, the red light blinks twice.
If you press RECALL, you will obtain the second channel
programmed (being <
23
>) and if you press RECALL again you will
obtain the first channel programmed (being <
12
>).
To reset the RECALL key,
1
Press
MAGIC and RECALL together
until the red light blinks
twice (the red light will blink once, then twice).
2
Press
RECALL
and release.
3
Press
MAGIC
and release (the red light will blink twice).
Important notes:
- The red light on the ONE FOR ALL will blink every 15 seconds indicating
that the remote is in Sleeptimer mode.
- To deactivate the Sleeptimer, press any key on the ONE FOR ALL remote.
Important notes:
- To enter only one channel number, skip steps 3 and 4.
- If two channel numbers have been stored previously, entering one new
channel will delete the oldest entry.
(:15)
(:30)
(:45)
(:60)
