10
2. Enter
9 9 5
. The LED will blink twice.
3. Select an open macro key (e.g.,
M1
) and press it once.
4. Press
CBL/SAT
once.
5. Enter the channel number:
5 2
.
NOTE:
If you have access to over 100 channels, enter
0 5 2
.
Moreover, if the original remote control requires you to press
ENTER
to change the channel, also press
ENTER
after the
channel number (e.g.,
0 5 2
ENTER
).
NOTE:
You can program up to 20 functions on the macro keys.
6. Press and hold
SET
until the LED blinks twice, then release
SET
.
Now when you press
M1
, you will instantly see cable channel 52
on your TV set.
Programming A Master Power Macro
In its default state, the
POWER
key on this remote will individually
power your home entertainment devices on or off. However, you
can also program a Master Power Macro onto the
POWER
key that
will sequentially turn on or off all the devices with a single key
press.
To Program the Master Power Macro
1. Press and hold
SET
until the LED (red light) blinks twice.
2. Enter
9 9 5
. The LED will blink twice.
3. Press the
POWER
key once.
4. For the first device you want in the power-on sequence, press
its device key (e.g.,
TV
) once.
5. For the second device you want in the power-on sequence,
press its device key (e.g.,
CBL/SAT
) once.
6. For the third device you want in the power-on sequence, press
its device key (e.g.,
AUD
) once.
7. Repeat step 6 up to five more times to add the other desired
devices to the power-on sequence (e.g.,
VCR
,
DVD
,
CD
,
PVR
,
and
AUX
).
8. To save the settings and exit the program, press and hold
SET
until the LED blinks twice, then release
SET
.
To Operate Master Power Macro
1. After programming, point the remote control at the devices
and press
POWER
for at least 2 seconds to sequentially turn on
(or off) your devices.
NOTE:
When you press
POWER
for less than 2 seconds, a power
command will only be sent to the currently-selected device. This
allows you to still individually power devices on or off.
2. Devices will turn on (or off) according to your programmed
sequence.
NOTE:
The currently-selected device will always turn on or off
first, followed by the remaining programmed sequence. After
the master power sequence has been completed, the remote
control will be set to control the first powered-on device.
NOTE:
If one or more devices does not have a
POWER
key,
the power off/on sequence may be slightly delayed when the
remote control signals the device(s).This action is normal.
Programming A Macro On A Device Key
In its default state, when you press a device key (e.g.,
TV
) on this
remote, the remote will switch to that selected device. However,
you can also program a Macro onto the Device keys to allow for
additional functionality. For example, if your devices are connected
to a receiver unit, you can program a Device macro to switch the
receiver’s input to the selected device.
Summary of Contents for URC8820N
Page 32: ......
