One for All URC8820N, User Manual

11

To Program the Device Key Macro 

For example, let’s assume that your DVD in connected to Input 
3 of your receiver. You can program a macro that will switch the 
receiver’s input to input 3 when you press and hold the 

DVD

 key. 

1.  Press and hold 

SET

 until the LED (red light) blinks twice, then 

release 

SET

. 

2.  Enter 

9 9 5

. The LED will blink twice. 

3.  Press the 

DVD

 key once. 

4.  Press the 

AUD

 key (to select the receiver). 

5.  Press digit 

3

 (for the input), and press 

DVD

 (to return control to 

the 

DVD

 key). 

6.  To save the settings and exit the program, press and hold 

SET

until the LED blinks twice, then release 

SET

. 

NOTE:

 You can program up to 20 functions on the Device Key Macro. 

You can program a device Key Macro onto any device key. 

To Operate the Device Key Macro 

1.  After programming, point the remote control at the receiver 

and press the 

DVD

 key for at least 2 seconds. This will switch 

the Receiver’s input to input 3, to allow you to view the DVD. 

NOTE:

 When you press the device key (e.g., 

DVD

) for less than 

2 seconds, the remote will only select the 

DVD

 mode but will 

not change the Input on the receiver. This allows you to still 
change modes while using the remote. 

NOTE:

 After executing the Device Key Macro, the remote will 

return to the 

DVD

 mode, to allow the control of the DVD 

device. 

Clearing A Macro 

1.  Press and hold 

SET

 until the LED (red light) blinks twice, then 

release 

SET

. 

2.  Enter 

9 9 5

. The LED will blink twice. 

3.  Select a macro key (e.g., 

M1

, 

M2

, 

POWER

 or any device key) 

you want to clear and press it once.

4.  Press and hold 

SET

 until the LED blinks twice, then release 

SET

. 

The macro is now deleted but the keys (in the case of 

POWER

and device keys), will retain their original function.

Using Channel Scan

In the 

TV

, 

VCR

, 

DVD

, and 

CBL/SAT

 modes, use the 

FAV

 key to 

start a 3-second scan of all favorite channels (if programmed, 
“Programming Favorite Channel Scan”) and/or all channels for the 
selected mode. 

1.  Press 

TV

, 

VCR

, 

DVD

, or 

CBL/SAT

 once. 

2.  Press 

FAV

 once. 

•     If Favorite Channel Scan has been set up, scanning of favorite 

channels will start and cycle through stored channels, then 
proceed to the next channel up and cycle through all channels 
on the selected device.

•     If Favorite Channel Scan has not been set up, scanning will start 

with the current channel, then proceed to the next channel up 
and cycle through all channels on the selected device. 

3.  To stop scanning channels at any time, press any key once.