One for All URC8820N, User Manual

13

Using Keymover 

This remote includes a Keymover feature that allows you to map (or 
copy) keys from one mode (i.e., source mode) to another mode (i.e., 
destination mode).

NOTE:

 The following keys cannot be used as a source or 

destination: 

TV

, 

CBL

/

SAT

, 

VCR

, 

DVD

, 

CD

, 

PVR

, 

AUD

, 

AUX

, 

FAV

, 

and 

SET

.

Programming Keymover

For example, if your VCR does not have volume control, you can 
map those keys (i.e., 

VOL +

, 

VOL -

, and 

MUTE

) from the TV mode 

to the 

VCR

 mode as follows:

1.  Press and hold 

SET

 until the LED (red light) blinks twice, then 

release 

SET

.

2.  Enter 

9 9 4

. The LED will blink twice.

3.  For the source mode, press 

TV

 once.

4.  For the source key, press 

VOL +

 once.

5.  For the destination mode, press 

VCR

 once.

6.  For the destination key, press 

VOL +

 once.

7.  The LED will blink twice, indicating the keymoved sequence is 

correct.

8.  Repeat steps 1 through 7 twice more to map remaining volume 

control keys, substituting 

VOL -

 and 

MUTE

 as source and 

destination keys in steps 4 and 6.

Upon completion of the above procedure, you can now use this 
remote to control the TV’s volume and 

MUTE

 in the 

VCR

 mode, as 

well as in the 

TV

 mode.

Restoring Keymoved Keys To Default Settings

Restoring a Single Keymoved Key

1.  Press a device key that has a keymoved key.
2.  Press and hold 

SET

 until the LED (red light) blinks twice, then 

release 

SET

.

3.  Enter 

9 9 4

. The LED will blink twice.

4.  Press the destination key twice (where the keymoved key is 

stored). The LED will blink twice.

Restoring All Keymoved Keys in a Single Mode

1.  Press and hold 

SET

 until the LED (red light) blinks twice.

2.  Enter 

9 9 4

. The LED will blink twice.

3.  Press the destination mode twice (where keymoved keys are 

stored). The LED will blink twice.

Restoring Factory Default Settings 

This remote includes a Setup Code Reset program. You can use it to 
restore all your programmed codes to factory settings and delete all 
custom programming. 

IMPORTANT:

 Executing this program erases all code settings and all 

custom settings including, Macros, Learned Keys, Reassigned Device 
Keys, Keymoved Keys, Favorite Channels, and all device settings. 
1.  On the remote control, press and hold 

SET

 until the LED (red 

light) blinks twice. 

2.  Enter 

9 8 0

. The LED will blink four times. 

3.  Your remote is now ready for programming.