SKU 95143
For technical questions please call 1-800-444-3353
Page 6
10. For extended spraying, you can lock the trigger in place. Squeeze the trigger,
move the Trigger Lock toward the base of the Handle and release the Trigger.
The sprayer will continue to spray. To release the Trigger Lock, squeeze the
Trigger and allow the Trigger Lock to return toward the front of the Handle.
Release the Trigger and spraying will cease.
11. During spraying, the initial pressure will be released from the Main Tank. When
you notice that more pressure is required, stop spraying. Turn the Pump
Handle (33) counterclockwise to release it from the Locking Ring (34). Pump
the handle up and down to rebuild pressure in the tank. When done, relock the
Pump Handle in the Locking Ring and continue spraying.
12. When done spraying, release pressure from the sprayer by pulling the
Pressure Relief Valve (31) straight up. Keep your face away in case any
material is ejected through the Pressure Relief Valve. Once all pressure is
removed from the tank you can empty any remaining material.
13. To empty the Main Tank, once pressure is removed, unscrew the Locking Ring
(34) by turning counterclockwise. Remove the Pump Assembly from the Main
Tank by pulling it up and out of the tank. Set the Pump Assembly aside.
Empty remaining material from the Main Tank into a suitable container.
14. Clean the tank and pump assembly thoroughly before storing. Be sure to
spray water or other suitable solvent through the sprayer to ensure that all
internal parts are clean before storage. It should not be necessary to
disassemble the sprayer for cleaning.
15. Store or dispose of excess spraying materials properly according to safe
practices and local ordinances. Store the sprayer in a clean dry location out of
reach of children or other unauthorized persons.
Using The Fan Pattern Spray Nozzle Assembly:
1.
Unscrew the standard spray nozzle assembly (1 - 4) from the Wand Nut (7).
Replace with Fan Spray Pattern Assembly (20 - 23). Be sure O-Ring (5) is in
place before tightening by turning clockwise.
Maintenance
1.
Always clean this sprayer thoroughly before and after each use. Do not allow
different materials used at different times to become mixed in this sprayer.
2.
After cleaning, dry thoroughly and store properly.
3.
If tank will not become pressurized, check all O-Rings and pressure relief
valve. Pressure Relief Valve must be pressed in to function properly.
