Page 6
SKU 97048
For technical questions, please call 1-800-444-3353.
SET UP INSTRUcTIONS
The Power Sprayer is shipped from the manufacturer with its Safety Lock (4) in
its “LOCKED” position. Keep the Safety Lock in its “LOCKED” position when
storing, changing chemicals in the Tank (9), or changing Batteries (10).
(See Figure A.)
The Power Sprayer comes with four “AA” Batteries (10). To install the Batteries,
open the Lid to the Battery Compartment (). Install the Batteries, following the
polarity indicators within the Battery Compartment. Then close the Lid to the Bat-
tery Compartment.
(See Figure A.)
In a separate container, mix the required amount of water and chemical accord
-
ing to the chemical manufacturer’s recommendations. Allow the water/chemical
solution to mix thoroughly. Undesolved particles may cause the Power Sprayer’s
Twist Nozzle (1) to clog. Pour the water/chemical mixture into the Power Spray-
er’s Tank (9). Then screw the Tank Cap (6), with its Pick-Up Tube (7), firmly onto
the Tank.
(See Figure A.)
OPERATING INSTRUcTIONS
Select “SPRAY” or “STREAM” marked in raised letters on the sides of the Twist
Nozzle (1) by turning the Nozzle before use.
NOTE:
Should you wish to use the Wand (8), unscrew (counterclockwise) and
remove the Twist Nozzle from the Sprayer (2). Screw (clockwise) the Wand (8)
onto the Sprayer. Then select “SPRAY” or “STREAM” by turning the tip of the
Wand.
(See Figure A.)
Slide the ON/OFF switch into the ON position.
Squeeze the Trigger (3), and wait several seconds for the system to prime.
(See Figure A.) Do not point the nozzle at any people or animals.
Spray the water/chemical solution at the selected area as recommended by the
chemical manufacturer.
When finished using the Power Sprayer, release pressure on the Trigger (3) to
stop the pump. Press the Safety Lock (4) to its “LOCKED” position. Return the
Sprayer (2) to its holder.
(See Figure A.)
Unscrew and remove the Tank Fill Cap (12) from the Tank (9).
(See Figure A.)
If necessary, fill the Tank (9) with clean water and spray for several seconds into
a pre-sprayed area to discharge any remaining chemicals trapped in the Pick-Up
Tube (7) and the pump. Dump the remaining water according to the chemical
manufacturer’s recommendations.
1.
2.
3.
1.
2.
3.
4.
.
6.
7.
