SKU 92508 For technical questions, please call 1-800-444-3353.
PAGE 5
ASSEMBLY INSTRUCTIONS
NOTE: For additional information regarding the parts listed in the following pages, refer to
the Assembly Diagram on the last page.
installed on. Visibly label the power
switch leading to the circuit, “Work in
progress on this circuit, DO NOT
TURN POWER ON.”
5.
Remove the cover from the outlet box.
Use a multimeter, set to a setting appro-
priate for testing 120 VAC, to determine
that the power to the outlet is truly dis-
connected.
6.
Parts 1-7 and 10 are typically preas-
sembled. Remove the Mounting Bracket
(8) if it is attached to the Base (1). Both
Bracket Screws (9) should remain
threaded into the Bracket - see below.
7.
Using an Outlet Box Screw (12) through
each slot in the Mounting Bracket (8), sol-
idly attach it to the outlet box.
The power to the outlet box must be disconnected before attempting to
install this item.
If the power is left connected during installation, or if the power comes on
accidentally, SEVERE PERSONAL INJURY or DEATH can occur.
1.
BEFORE STARTING THE INSTALLA-
TION MAKE CERTAIN THAT:
A. All needed tools and materials are
present at the work area. Weather-
proof sealant is not included.
B. Sufficient time is allotted for complet-
ing the installation.
C. It is a dry day with no chance of rain.
Leaving the work area without finishing
the installation creates a dangerous situ-
ation, and should be avoided at all costs.
2.
This device is installed on an electri-
cal circuit that has sufficient voltage
to SERIOUSLY INJURE or KILL you.
If any doubt exists about your capa-
bility to install this unit safely and
properly, this unit should be installed
by a licensed electrician.
3.
Select an appropriate switch-controlled
outlet box for installation. Having a
switch-controlled outlet allows quick dis-
connection in the event of an emergency.
The lantern’s mounting location:
A. Should be unblocked for optimal illu-
mination and sensor range.
B. Must not block or interfere with any
walkways.
C. Must be out of children’s reach.
4.
Disconnect all power connected to
the outlet box that this item is to be
Figure 1
